INSTALLATION INSTRUCTIONS FOR SADDLES
Note the following data for installing Golan brass saddles, electrofusion saddles and Krausz stainless steel saddles to Pexgol pipes.
Please note: Install all saddles onto the pipe prior to drilling the outlet hole.
Dimensions of drills for outlet hole in brass saddles
| Dimensions of drills for outlet hole in brass saddles | ||
|---|---|---|
| Brass saddles dimensions | Thread | Diameter and drill type |
| 32x¾” | Female | 13mm drill |
| 32x½” | Male | 13mm drill |
| 40x¾” | Female | 13mm drill |
| 40x½” | Male | 13mm drill |
| 50x¾” | Male | 22mm hole saw tooth |
| 63x¾” | Male | 19mm hole saw tooth |
| 63×1″ | Male | 24mm hole saw tooth |
| 63×2″ | Female | 45mm hole saw tooth |
| 75×1½” | Male | 35mm hole saw tooth |
| 75×2″ | Female | 45mm hole saw tooth |
| 90×1½” | Male | 33mm hole saw tooth |
| 90×2″ | Female | 45mm hole saw tooth |
| 110×2″ | Female | 45mm hole saw tooth |
| 160×2″ | Female | 45mm hole saw tooth |
Notes:
- Saddles up to 63 mm – 11 mm wrench
- Saddles 75 mm and 90 mm – 14 mm wrench
- Tighten the saddles until the two halves meet.
Dimensions of drills for outlet hole in stainless steel saddles
| Dimensions of drills for outlet hole in stainless steel saddles | |||
|---|---|---|---|
| Outlet type | Outlet size | Drill type | Drill diameter |
| Female outlet thread | 1½” | Hole saw tooth | 40 |
| Female outlet thread | 2″ | Hole saw tooth | 51 |
| Flanged outlet | 2″ | Hole saw tooth | 40 |
| Flanged outlet | 3″ | Hole saw tooth | 70 |
| Flanged outlet | 4″ | Hole saw tooth | 92 |
| Flanged outlet | 6″ | Hole saw tooth | 140 |
Install electrofusion saddles of all manufacturers (Plasson, Friatec, GF/Wavin) and Plasson mechanical saddles according to the manufacturer’s instructions.